Channel switching via footswitch

Double-Bubble! Place for discussing the 36W version...

Moderators: CurtissRobin, colossal, zaphod_phil, Daviedawg, Graydon

greaser_au
Newbie
Newbie
Posts: 54
Joined: Sun 10/22/06 2:00 am
Location: Adelaide, Australia

Post by greaser_au »

zaphod_phil wrote: FYI, here's another relay supply circuit someone sent to me. I've never tried it, and I'm not quite sure how it works...
I was curious, so I scribbled it out, it looks like the full-wave doubler shown here:
http://www.play-hookey.com/ac_theory/ps ... liers.html
with some added decoupling/filtering,

Naturally, it has the same problem that all the other schemes have, It is only suitable if the rectifier winding (the one normally used for directly heated diodes) is unused.

At a wild guess (i.e without trying to remember how to apply the maths again :oops: ) it should supply 12V or so at a few 10's of mA from a 5V winding.

david
0 x

User avatar
zaphod_phil
Builder, Admin
Builder, Admin
Posts: 14990
Joined: Wed 03/19/03 2:00 am
Location: YYZ

Post by zaphod_phil »

That's what I had a hunch it would be, but never got round to checking it out....
0 x
Nature abhors a clean tube amp

emartine
Unrated
Posts: 14
Joined: Sat 05/17/14 10:29 pm

Re: Channel switching via footswitch

Post by emartine »

I reflote this old topic. Is there an schematic of this mod somewhere on the site?
Its seems it existed somewhere in time. Thanks!
0 x

Post Reply