Conjunctive filter for 36 watter

Double-Bubble! Place for discussing the 36W version...

Moderators: CurtissRobin, colossal, zaphod_phil, Daviedawg, Graydon

Post Reply
User avatar
POWDOG
Newbie
Newbie
Posts: 39
Joined: Tue 09/27/05 2:00 am
Location: Cool

Conjunctive filter for 36 watter

Post by POWDOG »

Hey guys. RF was caused by some bad dress. Much nicer now. Curious about adding a conjunctive filter to take some of the brittleness out of the amp. Switchable, since I like it in some situations. I've used it before in 18 waters with good results. Like Hammonds, I've used a .002uF/2KV cap and a 10k/5 watt resistor in series between plates. Can I use these same values and run a single circuit between the OT primaries, or should I run two separate circuits? Just mucking around with ideas. Thanks.
0 x

rock_mumbles
Senior Amp Tech
Senior Amp Tech
Posts: 826
Joined: Mon 04/21/08 2:00 am
Location: Podunk, Idaho
Contact:

Re: Conjunctive filter for 36 watter

Post by rock_mumbles »

I would take the 18 watt values and halve the resistance since a 36 watt has 1/2 of the OT primary reflected impedance

Then double the cap value so the filter stays at about the same frequency

--==--

Here's a more involved approach you could get the parts at other places ...
http://www.tubesandmore.com/products/K-SNUB2" onclick="window.open(this.href);return false;
http://www.tubesandmore.com/sites/defau ... k-snub.pdf" onclick="window.open(this.href);return false;
0 x

Post Reply