Page 1 of 1
el85 - any good ?
Posted: Thu 02/21/13 4:55 am
by Gary
can el85 be used in a lite iib ? Any changes required ?
Re: el85 - any good ?
Posted: Sun 02/24/13 6:32 am
by Gary
is it safe to assume that the values used in ecl86 output stages will be suitable for el85 also ? There doesn't seem to be many el85 amps documented on the web!
Re: el85 - any good ?
Posted: Sun 02/24/13 3:23 pm
by davidw
Both specs here.
http://www.r-type.org/pdfs/el85.pdf" onclick="window.open(this.href);return false;
http://www.r-type.org/pdfs/ecl86.pdf" onclick="window.open(this.href);return false;
The following link is a useful resource but sadly doesn't have the EL95 but it has the ECL86 and typical operating conditions for EL85 are on the EL85 pdf above
http://www.4tubes.com/DATASHEETS/SCANS-Muiderkring/" onclick="window.open(this.href);return false;
Hope this helps
Re: el85 - any good ?
Posted: Sun 02/24/13 6:12 pm
by Gary
Thanks for that David; does anyone have any ballpark suggestions about cathode biasing resistor value? The mullard data refers to 310r in the operating conditions section fpr AB push pull~ so does that suggest a shared resistor of 150r to 180r for starters?