Mullard el38
Moderators: zaphod_phil, Daviedawg, Graydon, CurtissRobin, colossal
- Bulatovic
- Occasional poster
- Posts: 292
- Joined: Fri 12/08/06 2:00 am
- Location: Egham, UK / Belgrade, Serbia
Mullard el38
Guys, i just found a Mullard EL38 at my friend's who doesn't even know what is it, so it is virtually mine now
Can anyone tell me what is it like - i assume similar to EL34 or is it? Would you recommend to use it for a project?
Thanks
Can anyone tell me what is it like - i assume similar to EL34 or is it? Would you recommend to use it for a project?
Thanks
0 x
- zaphod_phil
- Builder, Admin
- Posts: 15208
- Joined: Wed 03/19/03 2:00 am
- Location: YYZ
It's a high power TV tube - nothing like an EL34. But you could use it in something like a Beast Champ or P1 eXtreme. The spec on http://www.mif.pg.gda.pl/homepages/fran ... e/EL38.pdf suggests using a 120 ohm cathode resistor with a B+ of 300V. So for a Beast Champ or P1eX, you would maybe need something like 150 or 180 ohms. Not sure what load impedance would be required, so a little work with load lines would probably be needed.
0 x
Nature abhors a clean tube amp