OT 50% tap question

General Tech Discussion - Anything amp-ish goes!

Moderators: CurtissRobin, colossal, zaphod_phil, Daviedawg, Graydon

Post Reply
Riffmonster
Newbie
Newbie
Posts: 54
Joined: Tue 02/09/16 12:38 pm

OT 50% tap question

Post by Riffmonster »

Hey guys,
hope all is goin well. I have an OT with two additional 50% primary taps that I don't want to use. Can I just isolate them and leave them untouched or is there anything I have to worry about?

Thanks and best regards
0 x

User avatar
colossal
Moderator
Moderator
Posts: 338
Joined: Thu 05/10/07 2:00 am
Location: In and around the lake

Re: OT 50% tap question

Post by colossal »

Yes, I would either clip off and/or heatshrink the ends so that no bare wire is exposed, consolidate the leads into a neat bundle and again heatshrink or ziptie. Then tuck them under the board, out of the way.
2 x

Riffmonster
Newbie
Newbie
Posts: 54
Joined: Tue 02/09/16 12:38 pm

Re: OT 50% tap question

Post by Riffmonster »

Thanks for the quick reply, much appreciated!
1 x

Post Reply