OT 50% tap question
Moderators: zaphod_phil, Daviedawg, Graydon, CurtissRobin, colossal
-
- Newbie
- Posts: 88
- Joined: Tue 02/09/16 12:38 pm
OT 50% tap question
Hey guys,
hope all is goin well. I have an OT with two additional 50% primary taps that I don't want to use. Can I just isolate them and leave them untouched or is there anything I have to worry about?
Thanks and best regards
hope all is goin well. I have an OT with two additional 50% primary taps that I don't want to use. Can I just isolate them and leave them untouched or is there anything I have to worry about?
Thanks and best regards
0 x
- colossal
- Moderator
- Posts: 450
- Joined: Thu 05/10/07 2:00 am
- Location: Moving through Kashmir
Re: OT 50% tap question
Yes, I would either clip off and/or heatshrink the ends so that no bare wire is exposed, consolidate the leads into a neat bundle and again heatshrink or ziptie. Then tuck them under the board, out of the way.
2 x
-
- Newbie
- Posts: 88
- Joined: Tue 02/09/16 12:38 pm