Jack (TriodeLuvr) is correct, you need to start with the right wire. You need pre-tinned (and preferably pre-bonded) wire. Using bare copper is a PITA, and you would still need to pre tin & bond it before soldering anything if you are going to use bare copper (which you shouldn't).davemojo wrote: ↑Thu 04/15/21 3:54 pmI will definitely fix this one, I got a little discouraged . I agree on patient and will look at the soldering video again and again. I will remove few parts that I already know are not ok and restart over on those parts example is the 2 green wires but also the mess at socket V3 there is a short in there for sure.
However I will first go through the entire steps looking at the layout I got and check all the soldering.
Thanks,
Josh
PS. The Lite 2b(ish) project you linked previously would be a great build for you after working through this one, and it's a great amp too.