36 watt Chassis Progress !!!
Moderators: zaphod_phil, Daviedawg, Graydon, CurtissRobin, colossal
-
- Frequent poster
- Posts: 893
- Joined: Sat 07/19/03 2:00 am
- Location: UK
- Contact:
36 watt Chassis Progress !!!
Using the standard'ish dimensions e.g. 20" X 6" ish X 2 1/2" I have punched 8 valve base holes, evenly spaced.
Photograph attached, it gives 2 1/4" between centres which is about the same as the standard 18 watt.
Steve UK
Photograph attached, it gives 2 1/4" between centres which is about the same as the standard 18 watt.
Steve UK
0 x
-
- Charter Member
- Posts: 4305
- Joined: Fri 03/14/03 2:00 am
- Location: Ky. USA
Yes nice start.. i should have trannys by early next week...
Then i'll have the board ready by the time my chassis get here..
but like you, i'll be taking more time,laying out the chassis,and punching the holes.. I believe i'll also build the head type first.. I have both a head and combo chassis.
Richie
Then i'll have the board ready by the time my chassis get here..
but like you, i'll be taking more time,laying out the chassis,and punching the holes.. I believe i'll also build the head type first.. I have both a head and combo chassis.
Richie
0 x
-
- Charter Member
- Posts: 4305
- Joined: Fri 03/14/03 2:00 am
- Location: Ky. USA