Page 1 of 1

6G3 build

Posted: Sun 09/12/21 3:16 pm
by Bieworm
Ok, I started building it. I bit the bullet and I'm not doing reverb on board. Next I'm building a stand alone reverb for that. I wanted one anyway...
The normal channel is a plexi like preamp, inspired on the Cutthroat Audio Down Brownie.
Power supply nearly finished. Heaters wired...
20210912_220416.jpg
20210912_221541.jpg

Re: 6G3 build

Posted: Wed 09/15/21 3:01 pm
by Bieworm
Did some more wiring. Push pull pot for parallel channels. And some other stuff...
Mojo f*cked up just another schematic... lol! They put the polarized cap on the bias board with negative to ground.. unbelievable!!!
20210915_215412.jpg
20210915_215408.jpg
20210915_215646.jpg

Re: 6G3 build

Posted: Wed 09/15/21 4:47 pm
by JMPGuitars
Are you publicly admitting to reading a mojo schematic?! Hahahahahahahaha

Re: 6G3 build

Posted: Wed 09/15/21 9:49 pm
by Bieworm
JMPGuitars wrote:
Wed 09/15/21 4:47 pm
Are you publicly admitting to reading a mojo schematic?! Hahahahahahahaha
I'm ashamed to admit .. but Yes. 😄!
It was the only clear schematic I could find. The f#nder ones are blurry ...the mojo one looked ok. It's not uncommon that electrolytics have their negative side connected to ground😉 LOL