Standalone reverb

General Tech Discussion - Anything amp-ish goes!

Moderators: Daviedawg, Graydon, CurtissRobin, colossal, zaphod_phil

Post Reply
chaliapin
Occasional poster
Occasional poster
Posts: 302
Joined: Tue 03/05/13 5:28 pm

Standalone reverb

Post by chaliapin »

What's the best option for 36w build? Id also like to use it in front of my 3w amp which doesn't have a loop. Looking at the fender type tube kit from tubetown or the also have a solid state lndverb which is cheap! I have a spring tank as I tried to make a spring pedal years ago but it never sounded any good. I need something tried and tested with layout/ schematic etc as I'm far from expert. Any suggestions?

I have to make an order from tube town this week for a few small parts to finish my amp, shipping is over 20e to Ireland so I could order my Christmas reverb present at the same time...


Sent from my SM-J600FN using Tapatalk

0 x

User avatar
Bieworm
Verbose Moderator
Verbose Moderator
Posts: 2416
Joined: Mon 02/10/20 8:24 am
Location: Belgium

Re: Standalone reverb

Post by Bieworm »

0 x
"THIS should be played at high volume..preferably in a residential area"

chaliapin
Occasional poster
Occasional poster
Posts: 302
Joined: Tue 03/05/13 5:28 pm

Re: Standalone reverb

Post by chaliapin »

Yes, I asked about the circuit on another thread but you probably didn't see

Sent from my SM-J600FN using Tapatalk

0 x

chaliapin
Occasional poster
Occasional poster
Posts: 302
Joined: Tue 03/05/13 5:28 pm

Re: Standalone reverb

Post by chaliapin »

I have an accutronics 3 spring tank

Sent from my SM-J600FN using Tapatalk

0 x

User avatar
Bieworm
Verbose Moderator
Verbose Moderator
Posts: 2416
Joined: Mon 02/10/20 8:24 am
Location: Belgium

Re: Standalone reverb

Post by Bieworm »

The one I posted the video about is current driven, so your tank won't likely be any good.
It is my take on the Lamington reverb unit, but with some extra's and tweaks
0 x
"THIS should be played at high volume..preferably in a residential area"

User avatar
Graydon
Admin, Charter Member
Admin, Charter Member
Posts: 1626
Joined: Fri 01/31/03 2:00 am
Location: USA
Contact:

Re: Standalone reverb

Post by Graydon »

My son, Isaac built what we think started life as a Weber Revibe kit and I was quite impressed with it. I am usually not a big fan of lo-fi effects. I much prefer rack effects for most things, especially reverb but this Revibe sounds pretty good. It was clear, and fairly natural and fairly tweakable. I could live with it for most of my guitar tones if I had to.
2 x
Sincerely,
Graydon Stuckey
www.gdsamps.com
www.guytron.com

User avatar
Bieworm
Verbose Moderator
Verbose Moderator
Posts: 2416
Joined: Mon 02/10/20 8:24 am
Location: Belgium

Re: Standalone reverb

Post by Bieworm »

As a reverb freak I will never get what I need out of rack units, for the same reason we want tube amps.
The downside of the stand alone units is the extra noise when you put it in series with the amp, pushing its front end. With my current builds the unit is built in the amp, well, it’s a different circuit though. But these amps don’t suffer from extra noise. I can’t explain it, but what I feared the most just isn’t there. Very quiet reverb noise floor.
https://youtu.be/9Mop42dizlg?feature=shared
1 x
"THIS should be played at high volume..preferably in a residential area"

Post Reply