Output Transformer Question

Forum to discuss amp circuits besides the 18 Watters and their ilk.

Moderators: JMPGuitars, Daviedawg, Graydon, CurtissRobin, colossal, zaphod_phil

Post Reply
sledder
Unrated
Posts: 1
Joined: Tue 05/16/23 4:22 pm

Output Transformer Question

Post by sledder »

I built a Ceriatone chupacabra and sounds great except for a problem with the output transformer 0 ohm lead. When I chopstick the lead I get either a depressed sound or a horrible yelp. There is a position where it works and sounds fantastic but it doesn't stay in that position. It appears that the lead connection to the OT is not a sound connection. I may attempt a repair or I may just buy a new OT but in the mean time I have a question. I am using an 8 0hm speaker. The OT has leads for 4, 8, and 16 ohms. Can I use the 8 and 16 ohm leads in lieu of the 0 and 8 ohm leads for the speaker jack connections? Numerically they both provide 8 ohms but not sure I am missing something.
0 x

User avatar
Bieworm
Verbose Moderator
Verbose Moderator
Posts: 2405
Joined: Mon 02/10/20 8:24 am
Location: Belgium

Re: Output Transformer Question

Post by Bieworm »

sledder wrote:
Tue 01/02/24 6:53 am
I built a Ceriatone chupacabra and sounds great except for a problem with the output transformer 0 ohm lead. When I chopstick the lead I get either a depressed sound or a horrible yelp. There is a position where it works and sounds fantastic but it doesn't stay in that position. It appears that the lead connection to the OT is not a sound connection. I may attempt a repair or I may just buy a new OT but in the mean time I have a question. I am using an 8 0hm speaker. The OT has leads for 4, 8, and 16 ohms. Can I use the 8 and 16 ohm leads in lieu of the 0 and 8 ohm leads for the speaker jack connections? Numerically they both provide 8 ohms but not sure I am missing something.
That’s a good question. Never thought of that, but I never had this happening either.
Although my gut feeling is that you could do it that way, but make sure the 0 and 4ohm taps are NOT connected. If you try it I would put a 500mA fuse on the B+ wire to the center of the primary side of the OT.
But better advice would be that you swap the OT for a good one. That’s what I would do.
0 x
"THIS should be played at high volume..preferably in a residential area"

Post Reply