Can someone teach me..very simple about Volts in 18watts

Tube-specific discussions

Moderators: colossal, zaphod_phil, CurtissRobin

Post Reply
User avatar
richon
Frequent poster
Frequent poster
Posts: 536
Joined: Sat 01/14/06 2:00 am
Location: Valparaiso , CHILE
Contact:

Can someone teach me..very simple about Volts in 18watts

Post by richon »

i plan to build a 18watts... a LiteIIb with a twist... in my country i can't those rectifier tubes... so i'll go for a diodes rectifier...

so i don't know what voltage i need from HV of the Power Transformer to make it work good
0 x

what_wires
Verbose poster
Verbose poster
Posts: 1282
Joined: Wed 08/11/04 2:00 am
Location: O-HI-O
Contact:

Post by what_wires »

Is there a center tap on the B+ winding?
0 x

User avatar
brownnote
Frequent poster
Frequent poster
Posts: 997
Joined: Wed 05/04/05 2:00 am
Location: CA
Contact:

Post by brownnote »

I'm going to guess 260V
Check duncanamps.com, there's a download for power supply calculator program...maybe that will help.
0 x
Remember kids...Always adjust for minimum smoke!

User avatar
richon
Frequent poster
Frequent poster
Posts: 536
Joined: Sat 01/14/06 2:00 am
Location: Valparaiso , CHILE
Contact:

Post by richon »

i don't know what a center tap is.... but i 've seen that TRanfos have a besides the 2 heaters cables..... 2 or 3 more cables..... is this it???
0 x

User avatar
markh
Charter Member
Charter Member
Posts: 1503
Joined: Wed 12/18/02 2:00 am
Location: SE PA, USA
Contact:

Post by markh »

A center tap is a wire connected to the center of the secondary winding. You normally ground/earth this wire, and then have the diodes connected to the two ends of the windings as shown in your picture.

--mark h
0 x

Post Reply