Newbee on this forum I say hello to All!
Two questions Richies Rev 2.0 of the 36 Watt, is this the updated good working schematic?
Also, is it possible collaborating with Nik's PT and OT?
TNX
Donations
Is the Rev 2.0 version the latest Good version
Moderators: colossal, zaphod_phil, CurtissRobin, Daviedawg, Graydon
-
lindee
- Unrated
- Posts: 14
- Joined: Thu 03/09/06 2:00 am
-
NitroLiq
- Verbose poster
- Posts: 1537
- Joined: Thu 02/03/05 2:00 am
- Location: NYC
The latest version can be found here:
http://www.18watt.com/modules.php?name= ... oad&cid=39
You can find much information about it in the "Re-Draw" thread here (look towards the middle of the page):
http://www.18watt.com/modules.php?name= ... c&start=60
I think most folks just get stand-up trannies straight from heyboer but if you order from Nik, I'm sure folks on the board can give you a hand getting it wired in right and Nikas well.
http://www.18watt.com/modules.php?name= ... oad&cid=39
You can find much information about it in the "Re-Draw" thread here (look towards the middle of the page):
http://www.18watt.com/modules.php?name= ... c&start=60
I think most folks just get stand-up trannies straight from heyboer but if you order from Nik, I'm sure folks on the board can give you a hand getting it wired in right and Nikas well.
0 x
-
lindee
- Unrated
- Posts: 14
- Joined: Thu 03/09/06 2:00 am
TNX Nitroliq,
I should be allright fitting Niks PT and OT into it.
The choke will be left behind and go for the resistor on the cap-can, if this resistor is the right one. I read many follow-ups with different values.
I first stick with a lager wattage see what happens with the 1K5 and Niks PT's B+
The grid resistors should go with a safe 150 ohms 5Watt I guess, see if I get in the right direction of 10-12V's per tube.
The PT will be an european version, the voltage out of our wallet differs very. 220V AC to 240AC so the PT is the struggeling............too hot or too cold, maby(I hope) just in the middle..........
I should be allright fitting Niks PT and OT into it.
The choke will be left behind and go for the resistor on the cap-can, if this resistor is the right one. I read many follow-ups with different values.
I first stick with a lager wattage see what happens with the 1K5 and Niks PT's B+
The grid resistors should go with a safe 150 ohms 5Watt I guess, see if I get in the right direction of 10-12V's per tube.
The PT will be an european version, the voltage out of our wallet differs very. 220V AC to 240AC so the PT is the struggeling............too hot or too cold, maby(I hope) just in the middle..........
0 x