Would this work on a VJ?

[teejoo]

Hi all, newbie here so be gentle

I've been wanting to gig with my VJ combo, but since we play pretty loud rock it has nowhere near enough power.

Can I use this: http://www.diyguitarist.com/GuitarAmps/LineOutBox.htm
safely on my VJ to slave it into another amp?

Do the resistors seem right?

Help is greatly appreciated.

[Mooreamps]

You know, this stuff ain't rocket science. I'm sure this configuration would work OK. I've seen about a half dozen different line out circuits, all different than my own. This circuit should be ok for what you want it for.

-g

[zaphod_phil]

Just make sure you always have a speaker plugged into the ouput, so your amp doesn't end up toasted.

[Bluesmechanic]

You know, this stuff ain't rocket science. I'm sure this configuration would work OK. I've seen about a half dozen different line out circuits, all different than my own. This circuit should be ok for what you want it for.

-g

Down boy, Down boy, It may not be rocket science to you, but to someone without an electronics background it could seem a bit confusing.
BTW, How are you at "Heart Surgery"?

[Manoteal]

If you don't want to use the speaker when you are doing the line out, add a 10 watt resistor from one of the outputs to common. The value of the resistor is what you can find that is closest to 4,8, or 16 ohms. A 10 watt, 10 ohm resistor will be fine for the VJ. Plug it into the 8 ohm output. It is close enough and you can find these at Rat Shack.Then make the line out the same way as your link.
M