Wannatone, just some notes/comments:
You must surely have a TB with the "add-on" board that is on the back of the amp. The "true" TB with tone controls on the top control panel has the additional tube as number six, closest to the power xformer, and most of its components added on the (somewhat longer) top board, closest to the power xformer. Don´t remember right off the bat if the bottom board is also a bit longer, the cathode components from the TB should go there...need to check my photos for that.
Besides, what version is your AC30 - Bass, Normal or Treble? Personally, I think it´s either a Normal or a Bass version, since I believe the Treble version has extra bright caps mounted directly on the volume pots, plus different values for coupling caps to and from the PI. To me, the Normal version actually sounds best (even better than the TB), but then, that´s me
The differences might be somewhat important to builders.
Finally, on your layout, I can´t seem to find the wires that go thru the chassis from the PI coupling caps to the power amp, (far right of the bottom board, right from the lower end of the fat 0,15 uF caps, from bottom edge of board thru rubber grommet)? Guess it´s just an oversight.
Great job in any case - thanks for putting time into it!
Cheers /Richard